How to Protect Your Concrete Equipments

1. The concrete batching plant should park in room. If park outside, you should choose the flat ground with covered board and then covered with waterproof cloth.
2. If with machines will be the long-term stored, it should maintain, replace the damaged parts and clean completely in order to keep good technical situation.
3. The arrangement of parking area which should make sure the machines don’t influence each other
4. The fuel control should put in idle position and the joysticks should place in neutral position
5. The protection of the motor.
a. Discharge the cold water
b. Change the engine oil. As usual the new oil is neutral, so it doesn’t erode the metal parts
c. The fuel tank should add fully to avoid rusting. You can also add antiseptic.
d. You should start the motor a time every month and drive the concrete batching plant at a short distance to make the lubricating points build new oil layer and prevent them from rusting. Attention: you should add cold water fully before start and discharge completely at end.
6. The storage of accumulator.
a. The accumulator should be kept in dry and anti-frozen place after it is disassembled.
b. The plumbic acid accumulator should be charged every month..
7. Anti-rust treatment.
a. Paint repair or painting of the whole concrete batching plants are determined by the area of anti rust paint
b. The anti-rust way of the working device is butter. Such as the bucket of loader and the scraper of motorized grader